Ever wonder how all-wheel-drive or 4-wheel-drive vehicles get the power from the engine to the front and rear wheels? The magic happens in what's called a transfer case.  In some all-wheel-drive vehicles, it's sometime called a power take-off unit, or PTU. Inside the transfer case is a set of gears.  And to keep those gears meshing smoothly, they have to be lubricated and kept cool.  What does that is called transfer case fluid. Depending on your vehicle's type of transfer case, it is filled with either an automatic transmission fluid, a gear oil that's a bit thicker or transfer case fluid designed to be use for your transfer case. As happens with all lubricating fluids, the transfer case fluid has things in it that break down the older they get.  They have corrosion inhibitors, detergents and anti-foaming agents that keep the lubricant from getting air bubbles in it. Transfer cases don't have filters in them to clean out impurities. If you don't have your transfer ... read more

No matter what the temperature is outside, it's important for your vehicle's engine to remain cool, calm, and collected.  Well, cool, anyway. If your vehicle has a gasoline engine, it's powered by a bunch of explosions involving spark plugs, pistons, gasoline, and air.  And the by-product of all those things working together? HEAT. There's a whole cooling system to keep everything at a tolerable temperature for your engine's parts, and a key part of that is the water pump.  Technically, it's pumping more than water. It should actually be called the "coolant" pump since the liquid that circulates through the system is a mixture of water and coolant.  Basically, the water pump keeps this coolant moving through your engine, where it picks up the engine heat, and then is pumped into the radiator where it gets rid of that heat.  When a water pump fails, the engine heat can build up.  When you get a warning light on the dash (either a gauge or a light) that show ... read more

If someone asked you what gas made up the largest portion of the atmosphere, what would you guess? Well, it's not oxygen; it only makes up 20.9 percent.  But since we're talking about oxygen, you should know that your vehicle uses oxygen sensors to make sure your engine is running the way it should. The oxygen sensors measure how much oxygen is in your exhaust.  If there's too much, it means there's a problem with the mixture of fuel and air.  The sensor sends signals to computers in your engine and adjusts the mixture so it maximizes performance and efficiency.  It does this constantly.  Many vehicles have multiple oxygen sensors.  Some have one close to the engine, another close to the muffler.  Two measurements are better than one since they allow readings to be more accurate.  You may have a vehicle with a dual exhaust, so you'd have twice as many oxygen sensors. Your oxygen sensors can fail.  One thing that can damage them is contaminat ... read more

You're heading down the road and you notice your vehicle is sputtering, like it's running out of gas.  But the gauge show's it's still got a quarter of a tank.  So what gives? It could be that your fuel pump is failing, meaning your engine is not getting enough gas to run properly.  While fuel pumps are built to last a long time, sometimes they fail.  Other symptoms you may have a bad fuel pump include your vehicle stalling and then refusing to start again, the engine overheating or a hum or whirr coming from around the gas tank.  Or, your Check Engine light may come on. Most fuel pumps are in the gas tank. They have a small electric motor in them.   When you bring your vehicle to our service center, a technician will run tests to confirm the fuel pump is getting power to it but has failed.  Some vehicles have an access panel so the fuel pump can be removed and replaced.  But in some vehicles that don't have that access panel, the technician ... read more